The figure below shows the band diagram of a tandem cell based on an amorphous and a microcrystalline silicon junction. In which position (A, B, C or D) are the electrons and holes, generated in the microcrystalline silicon junction, collected?
A. The holes are not collected at position A, B, C and D, but recombine with a light excited electron from the top cell at the recombination junction. The electrons are collected at
B. The holes are collected at D and the electrons at
C. The holes are collected at C and the electrons at
D. The holes are collected at D and the electrons at A, B, C or
查看答案
Consider a p-i-n a-Si:H solar cell. The various films are, from top to bottom: ZnO, a-Si:H (p-i-n), ZnO and Ag. Which deposition technologies and in which chronological order (from first processing step to the last processing step) are used to process the solar cell?
Why can't an a-Si:H solar cell rely on diffusion to separate the photogenerated carriers as much as a c-Si solar cell does?
A. The higher bandgap (around 1.7 eV) prevents the photogenerated carriers from diffusing through the intrinsic layer of the a-Si:H cell.
Because the absorption coefficient of a-Si:H is 70 times higher than that of c-Si in the visible region of the solar spectrum.
C. Because the diffusion length is around 300 nm, while in c-Si it is around 300 microns.
In the figure below the bandgap versus the lattice constant of various materials is shown.Which of the following statements is true?
A. The junctions of a lattice-matched triple junction solar cell can be based on the semiconductor materials GaInP, GaAs and Si.
B. If the bottom cell of a 4-junction cell is based on Ge, the first junction above the bottom cell is based on GaInAs.
C. A combination of three junctions based on the semiconductor materials GaInP, GaAs and Ge can only result in a metamorphic triple junction solar cell.
D. The semiconductor material InAs is a logic choice to be used as a top cell in a triple junction.
The figure below shows the I-V curves of two single junction solar cells. If you were to make a multi-junction solar cell with these two cells, which one will you put as a top cell?
A. Cell #1.
B. Cell #2.
微信支付 
支付宝支付