题目内容

Consider the following statements related to the field of MPPT techniques:a) The PV output is never steady at the MPP.b) Inclusion of a pilot solar cell can improve the PV module's yield.c) The hardware complexity is high for implementing this design.d) The output of the PV module is maximum only if load resistance = \(\frac{V_{mpp}}{I_{mpp}}\).Consider the following conditions at the PV output:i) An MPPT device implementing Fractional Open-Circuit Voltage method.ii) An MPPT device implementing Incremental Conductance method.iii) No MPPT device connected; solar module directly connected to the load.iv) An MPPT device implementing Perturb and Observe method. Which of the following matches the statements a) through d) with the right PV output conditions in i) through iv)?

A. a) - iv), b) - i), c) - iii), d) - ii).
B. a) - i), b) - iv), c) - ii), d) - iii).
C. a) - iv), b) - ii), c) - i), d) - ii).
D. a) - iv), b) - i), c) - ii), d) - iii).

查看答案

搜索结果不匹配？点我反馈

更多问题

With respect to a PV module's I-V and P-V curves, and the module's operating point, consider the following statements: a) When the operating point of the PV module is on the MPP (maximum power point), \(P_{mpp} \lt V_{oc} \times I_{sc} \). b) For a given irradiance and temperature condition, and a uniformly illuminated (all solar cells receive the same illumination) module with perfectly functional solar cells, there is one and only one MPP defined for the PV module. c) Assume that a simple fixed load of pure resistance R is connected directly to the PV module, and no MPPT device is connected to this setup. Under such a scenario, the operating point of the PV module will always coincide with the MPP, irrespective of the illumination conditions.d) The curvature of the I-V characteristics of a module around the region of MPP can be looked upon as a result of the non-ideal resistances of the solar cells that make up the module.Which of the above statements are true?

A. a) only
B. a), c) and d)
C. All statements
D. a), b) and d)
E. a) and b)

What is the new power output of the PV module in watts, under the ambient temperature of 15°C and 1000 W/m² irradiance? ______

Consider a crystalline PV module with the following output parameters mentioned at STC (Standard Test Conditions) conditions by the manufacturer.Pmax = 300 WVoc = 40 VIsc = 8 ANOCT = 40°CTemperature coefficient of power = -2 W/°CIf the ambient temperature falls to 15°C while the irradiance is 1000 W/m², what is the cell level temperature in ºC, as per the NOCT model? ______

During the winter, the inside of an average house is maintained at 20 ºC, while the outside temperature is 0 ºC. Assuming that the only mechanism of heat transfer is conduction, the walls are 10 cm thick and the heat conductivity of the walls is \(0.5 W/Km\). Calculate the heat flux from the room to the surroundings in \(W/m^2\). ______